Cheap Puma Espera Installation Of San Puma Espera

j4d5xminfy

eral provisions
1. Toilet, bathtub installed in the dome should paint brush (or dome), wall with cement mortar Scraping after formation. Low water tank, wash basin (sink) should be installed after the ceramic tile in the wall tiling.
2. Sanitary ware production quality requirements should be persistent with national criteria, there should be product appraisal.
3. Sanitary ware of the interlocking pipe, and far-bending should be uniform, not a bump and other defects.
Four. Sanitary ware installation, Expansion bolts should be adopted. Not use wood screws.
5. Sanitary ware aid, the installation bracket should be smooth, firm, and the utensil contacts should near.
6. Installation of sanitary ware, protective fathom should be taken.
Installation of sanitary ware
1. Use of sanitary ware varieties, descriptions, color, etc. should be consistent with household requirements.
2. Sanitary ware and into the water, sewage dismiss linkage must be tight [link widoczny dla zalogowanych], not water seepage, leakage phenomenon.
3. Sitting toilet installation, application of lime or silicone fuel tight connection.
4. Bath water should be aligned with downspouts, and do a good job sealing, do not use plastic pipe coupling. Alignment downspouts Department bathtub dado board should reside 200mm 160mm inspection chasm, install a small door. Shower faucet should be installed in the channel on the same side, cold water on the right, water on the left. Leading position should be correct. Bowl passport should be close to the wall.
5. Washbasin (sink) installation should be correct, hot and cold water pipe joints should be installed under the wash basin, chilly water on the right, water on the left.
6. Toilet and water tank installation place should be precise. Single place to allow discrepancy of 10mm, the vertical degree of tolerance should not exceed 10mm.
7. Sanitary ware installation height, should satisfy the provisions of
Monolithic cup mirror installed shall meet the following requirements:
1. Should be painted before installation, mirror on the back of a mirror back paint.
2. Installation should be in the mirror on the behind of a wafer of plywood and linoleum [link widoczny dla zalogowanych], with the wall.
3. Screws beneath the rubber gasket should pad, constrict the screw to the same degree.
4. Mirror back the applying of sealant nigh the breach embedded real.
Mirror box installation shall meet the following requirements:
1. Mirror Bottom margin from the ground, not less than 1m.
2. Mirror box fixed alternatively mounted on the wall, wall drilling depth of not fewer than 50mm, wood joints should be embedded in drilling [link widoczny dla zalogowanych], end inserted into the wall 10mm.
Towel rack (towel ring, towel bar, towel rack, etc.) must be according to the following provisions:
1. Towel ring mounting height from the ground 900-1400mm.
2. Towel bar mounting altitude from the ground-l100-1200mm.
3. Towel rack mounted on the wall upon the bathtub, from the ground 1600mm.
4. Towel rack on the wall should be firmly fixed, fixed office should be clean and smooth.
Bath handle the installation, shall meet the following requirements:
1. Bathtub deal mounted ashore the top side wall of the bathtub, there are levels, diagonal, perpendicular 3 varieties of installation, ought be determined according to household requirements.
2. Minimum installation of three ground-fixed dot pitch should as 600mm.
3. Bathtub handle mounted on the wall, should be firmly fixed, firm bureau should be flat and neat.
Project Acceptance
1. Product kind, size, color, etc. should be consistent with household requirements, product quality should be consistent with present citizen standards.
2. Installation location should be correct there should be no seepage, leakage phenomenon.
3. Sanitary ware and appliances installed after the installation should be no abuse,